Damage buildup and edge dislocation mobility in equiatomic multicomponent alloys

Forskningsoutput: TidskriftsbidragKonferensartikelVetenskapligPeer review

Sammanfattning

A new class of single phase metal alloys of equal atomic concentrations has shown very promising mechanical properties and good corrosion resistance. Moreover, a significant reduction in damage accumulation during prolonged irradiation has also been observed in these equiatomic multicomponent alloys. A comparison of elemental Ni with the two component NiFe- and the three component NiCoCr-alloy showed a substantial reduction in damage in both alloys, and an even larger difference was seen if only larger clusters were considered. One of the factors limiting the damage build-up in the alloys compared to the elemental material was seen to be dislocation mobility (Granberg et al., 2016). In this Article, we focus on a more thorough investigation of the mobility of edge dislocations in different cases of the Ni-, NiFe- and NiCoCr-samples. We find that even though the saturated amount of defects in the alloys is lower than in elemental Ni, the defect buildup in the early stages is faster in the alloys. We also find that the dislocation mobility in NiFe is lower than in Ni, at low stresses, and that the onset stress in NiFe is higher than in Ni. The same phenomenon was seen in comparison between NiFe and NiCoCr, since the three component alloy had lower dislocation mobility and higher onset stress. The dislocation velocity in elemental Ni plateaued out just under the forbidden velocity, whereas the alloys showed a more complex behaviour. (C) 2016 Published by Elsevier B.V.
Originalspråkengelska
TidskriftNuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms
Volym393
Sidor (från-till)114-117
Antal sidor4
ISSN0168-583X
DOI
StatusPublicerad - feb 2017
MoE-publikationstypA4 Artikel i en konferenspublikation
EvenemangComputer Simulation of Radiation effects in Solids - Loughborough, Storbritannien
Varaktighet: 19 jun 201624 jun 2016
Konferensnummer: 13

Vetenskapsgrenar

  • 114 Fysik

Citera det här

@article{b262e44136a3420f9c60470ae0aabac6,
title = "Damage buildup and edge dislocation mobility in equiatomic multicomponent alloys",
abstract = "A new class of single phase metal alloys of equal atomic concentrations has shown very promising mechanical properties and good corrosion resistance. Moreover, a significant reduction in damage accumulation during prolonged irradiation has also been observed in these equiatomic multicomponent alloys. A comparison of elemental Ni with the two component NiFe- and the three component NiCoCr-alloy showed a substantial reduction in damage in both alloys, and an even larger difference was seen if only larger clusters were considered. One of the factors limiting the damage build-up in the alloys compared to the elemental material was seen to be dislocation mobility (Granberg et al., 2016). In this Article, we focus on a more thorough investigation of the mobility of edge dislocations in different cases of the Ni-, NiFe- and NiCoCr-samples. We find that even though the saturated amount of defects in the alloys is lower than in elemental Ni, the defect buildup in the early stages is faster in the alloys. We also find that the dislocation mobility in NiFe is lower than in Ni, at low stresses, and that the onset stress in NiFe is higher than in Ni. The same phenomenon was seen in comparison between NiFe and NiCoCr, since the three component alloy had lower dislocation mobility and higher onset stress. The dislocation velocity in elemental Ni plateaued out just under the forbidden velocity, whereas the alloys showed a more complex behaviour. (C) 2016 Published by Elsevier B.V.",
keywords = "114 Physical sciences",
author = "Fredric Granberg and Flyura Djurabekova and Emil Levo and Kai Nordlund",
note = "Volume: 393 Proceeding volume:",
year = "2017",
month = "2",
doi = "10.1016/j.nimb.2016.11.012",
language = "English",
volume = "393",
pages = "114--117",
journal = "Nuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms",
issn = "0168-583X",
publisher = "Elsevier",

}

TY - JOUR

T1 - Damage buildup and edge dislocation mobility in equiatomic multicomponent alloys

AU - Granberg, Fredric

AU - Djurabekova, Flyura

AU - Levo, Emil

AU - Nordlund, Kai

N1 - Volume: 393 Proceeding volume:

PY - 2017/2

Y1 - 2017/2

N2 - A new class of single phase metal alloys of equal atomic concentrations has shown very promising mechanical properties and good corrosion resistance. Moreover, a significant reduction in damage accumulation during prolonged irradiation has also been observed in these equiatomic multicomponent alloys. A comparison of elemental Ni with the two component NiFe- and the three component NiCoCr-alloy showed a substantial reduction in damage in both alloys, and an even larger difference was seen if only larger clusters were considered. One of the factors limiting the damage build-up in the alloys compared to the elemental material was seen to be dislocation mobility (Granberg et al., 2016). In this Article, we focus on a more thorough investigation of the mobility of edge dislocations in different cases of the Ni-, NiFe- and NiCoCr-samples. We find that even though the saturated amount of defects in the alloys is lower than in elemental Ni, the defect buildup in the early stages is faster in the alloys. We also find that the dislocation mobility in NiFe is lower than in Ni, at low stresses, and that the onset stress in NiFe is higher than in Ni. The same phenomenon was seen in comparison between NiFe and NiCoCr, since the three component alloy had lower dislocation mobility and higher onset stress. The dislocation velocity in elemental Ni plateaued out just under the forbidden velocity, whereas the alloys showed a more complex behaviour. (C) 2016 Published by Elsevier B.V.

AB - A new class of single phase metal alloys of equal atomic concentrations has shown very promising mechanical properties and good corrosion resistance. Moreover, a significant reduction in damage accumulation during prolonged irradiation has also been observed in these equiatomic multicomponent alloys. A comparison of elemental Ni with the two component NiFe- and the three component NiCoCr-alloy showed a substantial reduction in damage in both alloys, and an even larger difference was seen if only larger clusters were considered. One of the factors limiting the damage build-up in the alloys compared to the elemental material was seen to be dislocation mobility (Granberg et al., 2016). In this Article, we focus on a more thorough investigation of the mobility of edge dislocations in different cases of the Ni-, NiFe- and NiCoCr-samples. We find that even though the saturated amount of defects in the alloys is lower than in elemental Ni, the defect buildup in the early stages is faster in the alloys. We also find that the dislocation mobility in NiFe is lower than in Ni, at low stresses, and that the onset stress in NiFe is higher than in Ni. The same phenomenon was seen in comparison between NiFe and NiCoCr, since the three component alloy had lower dislocation mobility and higher onset stress. The dislocation velocity in elemental Ni plateaued out just under the forbidden velocity, whereas the alloys showed a more complex behaviour. (C) 2016 Published by Elsevier B.V.

KW - 114 Physical sciences

U2 - 10.1016/j.nimb.2016.11.012

DO - 10.1016/j.nimb.2016.11.012

M3 - Conference article

VL - 393

SP - 114

EP - 117

JO - Nuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms

JF - Nuclear Instruments & Methods in Physics Research. Section B: Beam Interactions with Materials and Atoms

SN - 0168-583X

ER -